|
ScrapStar Mark II 62-Cubic yard Frameless Scrap Dump Trailer
The Clement ScrapStar Mark II for Rugged, Unrestricted
Scrap
37-ft, 62-cubic yard
Frameless Scrap Trailer
You don't see savvy scrap haulers buying the same
trailer again and again unless it's making them money, lots of money.
Clement ScrapStar, Mark II is designed and configured for maximum profitability
with high-strength, abrasion resistant steel (AR450) that gives you
the ability to haul the full spectrum of scrap. Premium components,
which are options on competitor's trailers are standard of every Scrapstar.
That's because money is made on the road, not in a repair shop. Add
Clement's superior design and construction and you have a solid moneymaker.
Premium Components are standard on the ScrapStar
because money is made on the road, not in the repair shop.
 |
The Clement Bathtub body, with its 8 inch radius wrap floor with
no center seam, is supported by longitudinals rather than cross
members. This design has been so successful that it has become
the most imitated body in the industry.
Urethane Paint
A Class-8, truck-quality urethane paing is applied to ensure
maximum protection and long life.
|
| |
|
|
Proven in hundreds of thousands of trailers, the 25,000# axles
used in Clement Scrap trailers feature common inner and outer bearings.
In combination with Meritor's parallel spindle, both axle and bearing
life is substatially increased. |
| |
|
 |
Clement's Inverted Cylinder
With an inverted
cylinder there’s
no doghouse. An inverted cylinder has no ledges to collect dirt,
water and ice, so the cylinder packing remains clean with no
dirt pulled into the system. In an inverted cylinder, oil lays
on the seals when the trailer is not in use, keeping the seals
lubricated to prevent dryout and cracking.
|
|
SPECIFICATIONS
|
CHASIS
- Suspension: 50,000 # Single
Point - 3
- Leaf Axles: (2) 102", 25, 000 lb,
5" Round, Common Inner/Outer Bearings
- Wheels: 8.25 x 24.5, 10 Hole Hub-Piloted
Disc
- Tires: 11 x 24.5 Radial
- Hubs: 10 Hole Pilot Hub
- Brakes: Air 16 1/2 x 7" Outboard Cast Drum
- ABS: 2S 1M Axle Spacing: 51"
- Lights: 12 Volt Sealed Beam, Rubber Grommet
- Wiring: Sealed Harness Modular Plug in
- Mud Flaps: Rubber Rear Only
- Draft Arms: 3" x 4" 1/8 Tubing
- King Pin Plate: 1/4" AR450 (Rocking/Breakaway)
- Back-up Alarm: Yes
|
BODY
- Type: Steel Bathtub style body
for steel scrap
& demolition
- Floor: Full Wrap: 1/4" AR450
- Sides: 3/16" AR450
- Tailgate: Barndoor 3/16" AR450
- Front: 3/16" AR450
- Paint: One color urethane enamel over primed surface
- Longitudinal: 4" x 4" x 3/16" Tubing
- Top Rail: 4" x 4" x 3/16" Tubing
- Side Braces: 3/16"
- Hoist Housing: None - Inverted Outside Hydraulic
Cylinder
|
|
| |
Mark
Overholt -Tiger General, Inc. 6867 Wooster Pike Medina,
Ohio 44256
Call Toll
Free: 1-800-433-5608 |
|
