|
Rockstar 450 - Half-Round Frameless End Dump
From sand & gravel to boulders, there's no load
too tough for the Rockstar 450!
|
 |
|
Strong, Superior
AR 450
The stronger the steel, the greater its
resistance to dents and cuts. Here's how that applies to the
RockStar 450. Resistance to dents is measured in yield strength
and resistance to cuts is measured in Brinell hardness. AR450
steel combines the highest yield and tensile strength that steel
technology can provide: 32 percent greater yield strength and
36 percent greater tensile strength than AR400 steel. Compared
to T-1 steel, AR450 provides 87 percent greater yield strength
and 106 percent greater tensile strength. AR450 is used in all
Clement RockStar 450 body panels, including the headboard and
tailgate. Measured against the hi-tensile steel used by some
manufacturers in their headboards and tailgates, AR450 provides
240 percent greater yield strength. Wear superiority
from AR 450
The harder the steel, the greater its wear life.
Clement's RockStar 450 is built with the hardest steel that can be provided.
AR450 is 25 percent harder than AR400 and 138 percent harder than hi-tensile
steel. This translates into increased trailer life for Clement's RockStar 450.
AR450 is so hard that it will stand up under this comparison: Compare the 5/16
inch AR400 used by some manufacturers in the last 8 feet of their trailer bodies
against the 1/4 inch AR450 used by Clement for all body panels. Clement's AR450
steel far exceeds the wear life of the competition's AR400. |
The RockStar 450's superiority
You be the judge and compare Clement's RockStar 450 with its 1/4 inch
AR450 to what other manufacturers offer. You'll see the difference. Beat
it, abuse it, treat as rough as possible. No one builds a tougher trailer
than the Clement RockStar 450.
102-inch,
25,000 lb. axles in combination with 50,000 lb .suspension
Proven on hundreds of thousands of trailers,
25,000 lb. axles feature common inner and outer bearings.
Combined with parallel spindle, both axle and bearing
life are substantially increased. With hub-piloted
wheels, maintenance time and costs are reduced. And
50,000 lb center point suspension provides maximum
stability for either off or on road conditions.
|
|
|
Dumps
with wheels to the ground 41 degrees
Wheels on the ground is standard on the RockStar 450. Wheels off the ground is
optional for those requiring higher spill points. |
333
pounds lighter without longitudinals
The RockStar 450 comes standard without longitudinals, thereby reducing trailer
weight by 333 pounds for larger payloads without sacrificing trailer strength.
Optional on request are longitudinals at rear of trailer. |
Air-lift gate with 81-inch opening
The RockStar 450's standard air-lift gate has an 81-inch opening which is
larger than competitive trailers and improves discharge. Mud flaps are
attached to the tailgate to reduce flap damage. |
|
Clement's inverted
cylinder
Clement's exclusive combination
king pin plate allows for fast and easy conversion
to either a break-away or a non break-away cylinder
shaft to suit individual requirements. Without inverted
cylinder there's no dog-house interfering with the
load. And since the kingpin is located forward, the
bridge length is longer allowing greater gross weights. |
|
| SPECIFICATIONS |
- 1/4-inch AR450 steel
body, headboard and tailgate
- 32-foot inside length
- 45-inch sides for 26 cubic yards
3/16”x 4.5”x 8”
- Top rail with fabricated inverted angle at top for
dirt shedding
- Air-lift gate providing 81-inch opening mud flaps
attached to the tailgate
- Rear fenders of aluminum tread plate
- Parking legs attached to draft arms
- Extra long longitudinals under floor
- Wide-angle stabilizer arms
- Combination break-away/non break-away hoist shaft
|
- Dumps with wheels on the ground thru 41 degrees
- Inverted 85-235 hydraulic cylinder 50,000 lb.
- Center point suspension
3/4-inch wall trunnion tube
- 25,000 lb. axles, 102-inch wide track
Same size inner and outer wheel bearings
- Hub-piloted wheels 8.25 x 24.5 10 hole
- 11R 24.5 radial tires
- Outboard brake drums
- Weight: 13,483 lbs. without longs +/- 3% 13,816
lbs. with longs +/- 3%
- WABCO ABS brake system —
02S-1M
- Acrylic urethane paint
|
|
| |
Mark
Overholt -Tiger General, Inc. 6867 Wooster Pike Medina,
Ohio 44256
Call Toll
Free: 1-800-433-5608 |
|
